Megan Racing Front RCA and Install

After deciding that I needed to adjust the front roll center, as well as add some additional negative camber, I grabbed a set of these. They should help me get the front camber bumped up from -2.3 to about -3.4.

The rear of the car seems to be operating the way its supposed to. But the front feels like its rolling a bit much. These will bring it back into spec.

Installing is easy. Just make sure that you’ve got a ball joint separator tool. I went ahead and swapped the tie rod ends at the same time, since the boots were torn and leaking grease. I followed Rob Robinette’s installation guide, so no need to go over each step again here.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s